Simply seen they censored my sh*t. I assume as an OCD stringer first clear your tray, the little snippits from reducing your tails is an eyesore for the OCD stringer =P
Your mains look very environment friendly, measurement by hand is superb. One factor I would say is possibly keep away from shaking the machine, I’ve seen you clamp with out shaking the machine however you usually shake it a bit of, it’s kinda like prestretching your string. Preweaving mains, I often do if I need to waste time, do not you suppose it’s a little redundant, pull some string by means of little by little then return after which pull it by means of once more? Perhaps in case you are not stringing over 30, the Yonex final 2 mains end just isn’t so essential, so possibly pull your important #10 so your clamps aren’t in your manner when preweaving your crosses, I may additionally study to go backwards in your cross too I often begin my cross preweave on 10 and return to 9 so I do not pull my entire string by means of cross #9. When your string begins to spin once you pull your cross possibly maintain the spinning string so it would not spin and pull it a bit of slower by means of so it stops spinning/twisting.
As a stringer some movies I can not watch the entire video, I must skip however watched your video during and was entertained, not board watching the entire thing. I feel your effectivity will come by means of observe, one factor to observe is to seek out the angles that your machine pulls, attempt to keep away from your racket shaking, when you’ve gotten stress pulled it’s best to see your stress flucuating when your racket is shifting. Attempt to keep away from that. F*ckin nice video, I picked up a few issues from you, that I would need to strive, I do not use a string mover however I noticed you pull your string up with it in your final shared gap, I would strive with my axe.
While you do your racket inspection, I would have a look at the grommets, the one cross cross that’s lined, whether it is effectively worn, I exploit a grommet grinder to show it 1 / 4 flip, truly I’ve simply gotten into the behavior of turning them, particularly Yonex rackets, I teust they’re off centered so I do not fear about placing in that additional string to maneuver that lined cross. I can see a sub 25 minute string job in about 2 weeks with observe and possibly 6 months sub 22-23. Your weaving has potential, you aren’t sluggish. While you hit 50 although sub 20’s get a bit of robust =P
Despatched from my SC-01L utilizing Tapatalk